TCI Driver LED DC JOLLY 32W Dimmable

Operating mode

Brightness adjustment 0/1 - 100% via PUSH function, local interface 0/1...10 V (I=0.35 mA) or 100 Kohm potentiometer. Default AM+PWM adjustment: 1-25% PWM 2 kHz+25-100% AM. PWM regulation only (240 Hz - 1-100%) and Constant Voltage 12/24V can be achieved by removing JP3. Enter JP3 to enable AM+PWM. Brightness adjustment 0/1 - 100% via the PUSH function (mains voltage L; 170 Kohm): a short press to turn on and off; a long press to increase or decrease the light intensity; the regulation stops automatically at the minimum and maximum values; for a new on, adjustment or off command, release the button and give the desired command again; restore the dimming level when the power supply returns. The maximum length of the cable, from the button to the last transformer, must be max. 15m / 49ft. In case of applications where the cable exceeds 15 m / 49 ft, keep it separate from the 110 - 240 Volt mains cable. ATTENTION: use only normally open type buttons without a built-in indicator light. Equipped with a specific terminal for regulation by connecting an electronic potentiometer 0/1...10 Vdc (local dimming 0/1...10 V, for connections external to the device ensure double insulation). Max. 10 synchronized drivers, of which only one controlled by one or more points (1 Master+9 Slaves any driver from the JOLLY Series). For PWM regulation only. Sync cable supplied separately. DALI and DMX control is possible via DALI/DMX IN

Selection via dip-switch of the constant output current Variants:

• 13 (13)W 15...53V - 250 mA const.
• 16 (15)W 15...53V - 300 mA const.
• 18 (15)W 10...53V - 350 mA const.
• 21 (15)W 10...53V - 400 mA const.
• 23 (15)W 5...52V - 450 mA const.
• 25 (15)W 2...50V - 500 mA const.
• 27 (15)W 2...50V - 550 mA const.
• 30 (15)W 2...50V - 600 mA const.
• 32 (15)W 2...49V - 650 mA const.
• 32 (15)W 2...46V - 700 mA const.
• 20 (15)W 2...27V - 750 mA const.
• 20 (15)W 2...25V - 800 mA const.
• 20 (15)W 2...24V - 850 mA const.
• 20 (15)W 2...22V - 900 mA const.

Constant voltage output - Constant voltage output

11 (11)W 12 const. 900 mA max.

20 (15)W 24 const. 830 mA max.

* The power in W between walls refers to the 110-120V current

For more information, see the attached PDF