Flos A-Round 315 Adjustable Recessed Ground Spotlight For Outdoor IP67

External ring in AISI 316L stainless steel treated with PVD (Physical Vapor Deposition) process. Thanks to this innovative treatment, the surfaces of the A-Round are covered with a thin film of metals such as zirconium and titanium which, when combined with steel at the molecular level, increase the characteristics of both mechanical and atmospheric agents resistance, allowing the creation of precious and durable finishes. Luminaire body made of die-cast EN AB-47100 aluminum with low copper content, coated with a double layer of high corrosion resistance paint. High-strength tempered transparent glass, silk-screened to reduce glare. Driver for remote installation included, supplied with watertight M12 quick coupling connector. Installation requires a recessed formwork, to be ordered separately. Adequate gravel level (> 300 mm) must be ensured or a drainage system must be provided to ensure drainage and prevent water stagnation. To ensure the tightness of the cable gland it is necessary to use flexible electrical cables suitable for use in outdoor environments. Integrated 110 / 240V power supply. Formwork required, to be ordered separately. Dimmable version on request. Adjustability on the horizontal axis: max 15 °. Rotation around the vertical axis: max 359 °.

It is necessary and mandatory to install A-Round spotlights on a compatible formwork, which is not included but can be purchased separately.

• led lamp
• Power (W): 8 CCT
• (K): 3000K e 4000K
• CRI: 80
• Net lumens (lm): 479
• Supports: Ground recessed
• Environment: for outdoors
• Optics Type of lighting: Direct
• LED type: Power LED
• Light distribution: Symmetric
• Optic type: Flood down
• Beam angle (°): 14 - 25 - 64
• Beam angle C90-270 (°): 14 - 25 - 64
• Electrical Frequency (Hz): 50-60
• Voltage (V): 110-240
• Driver: remote included
• Driver type: non-dimmable and DALI dimmable (1-10V dimmable on request)
• Insulation class: II
• Physical Color: Copper, Bronze, Gold, Stainless
• Orientation: orientable Rotation (°): 359

Notes: It is recommended to use a connection system with a degree of protection equal to or higher than that of the fixture. During installation and maintenance of the fixtures, particular care must be taken not to damage the powder coating. Any damage, combined with water exposure, could lead to corrosion. Chemical products damage the anti-corrosion protection. LED fixtures may exhibit faults due to electrical stress affecting the insulation, potentially causing destructive electrical discharges. These stresses may result from: overvoltages coming from the electrical power supply network, or electrostatic discharge (ESD) originating from the environment. We recommend installing a surge protection device on the electrical system, which helps reduce the intensity of some of these phenomena, protecting the fixtures from irreversible damage. The choice of the most suitable device should be based on the characteristics of the system.