Flos In Vitro Bollard floor lamp for outdoor

The structural parts of the appliance are made of die-cast and extruded aluminum treated with a chemical conversion process in order to achieve an efficient resistance to atmospheric agents.

The body is powder coated and available in various finishes. Integrated LED light source with Edge Lighting optical technology to ensure perfect light uniformity. Integrated on-off or dimmable 100-240V power supply. The device is supplied with a watertight connector for connection to the mains. The device can be installed on any floor by means of anchors. Formwork for installation on the floor to be cast with a concrete plinth to be ordered separately.

Designer: Philippe Starck

• Lamp category: LED
• Power (W): 11
• CCT (K): 3000K
• CRI: 80
• Net lumens (lm): 714
• Supports: ground
• Environment: for outdoors

• Type of lighting: Direct
• LED Type: Edge Lighting
• Light distribution: Symmetric
• Optic type: Diffused light
• Beam angle (°): 111
• Beam angle C90-270 (°): 11

• Frequency (Hz): 50-60
• Voltage (V): 100-240
• Dimmable
• Driver: integrated
• Driver type: Electronic dimmable DALI
• IP66 protection degree. Insulation class: I.

• Colors: Anthracite, Black, White, Forest Green, Pale Green, Terracotta and Brown
• Orientation: fixed
• The Dali and 110V dimmable version with 3000K or 2700K light is available on request

Notes: It is recommended to use a connection system with a degree of protection greater than or equal to the degree of protection of the device. During the assembly and maintenance of the devices, special care must be taken not to damage the powder coating. Combined damage to the action of water could cause corrosion. Chemicals damage the corrosion protection. LED luminaires can show faults attributable to electrical stresses affecting the relative insulation with triggering of destructive electrical discharges. These stresses may arise from: . overvoltages from the power supply network of the system / appliances. . overvoltages of electrostatic origin (ESD) from the environment. We recommend the installation of a surge protection device on the electrical system that attenuates the intensity of some of these phenomena, protecting the appliances from irreversible damage. The choice of the most suitable device must be calibrated according to the characteristics of the system.