Dyson Airblade Tap Wash Dry Sink Hands Dryers Wall-Mounted

Product Information:

Stop spilled water on the floor

With the Airblade Wash + Dry drying technology, you can dry your hands on the sink in just 14 seconds. It is not necessary to go to a separate drying area and then eliminate the problem of water spread on the floor.

Free the toilets
The installation of the other towels requires a lot of space both on the wall and on the floor. With the Dyson Airblade Wash + Dry towels you save valuable space in the corridors and other toilet areas.

Airblade drying technology in a faucet
Every second, conveys up to 21 liters of air filtered through the HEPA filter through cracks with a maximum diameter of 0.55 mm. The result - Blades of filtered air pushed at speeds of 549 km / h that literally remove the air from the hands and dry them hygienically in just 14 seconds.

Save your money
The annual running costs of the Dyson Airblade Wash + Dry towels are averaging around ‚¬ 34. Up to 78% less than paper towels and up to 98% less than other towels.

Reduces waiting times in the bathrooms
The Dyson Airblade Wash + Dry towels take only 14 seconds to dry your hands completely. Users spend less time in the bathroom, and it is easier to manage periods of intensive use.

The Dyson digital engine technology
The Dyson V4 digital engine is one of the world's smallest fully integrated 1000 W engines. It reaches up to 81,000 rpm and is the only towel motor powerful enough to make Airblade „¢ technology possible.

Dry hands with clean air
Dyson Airbalde Was + Dry towels use HEPA filters that capture 99.95% of bacteria and viruses in the air. The drying is then done with clean and uncontaminated air.

HEPA filtration
The HEPA filter removes particles in the air. The filter features a grid that captures larger particles of dirt, a layer of woven fabric that blocks powders and fibers, and a layer of pleated HEPA material to filter particles up to 0.1 microns.

Factors to consider before installation
Installation areas
Use suitable only for internal areas and places. Maximum elevation 2000 m.

Power supply
15 A per unit. Type of supply / Frequency: 200-240 V, 50/60 Hz. Rated power: 1000 W.

Hydraulic power supply
Required water pressure: 1-8 bar. 1/2 "BSP pipe thread

Model codes:

WD04 DYSON AIRBLADE WASH + DRY SHORT NECK

WD05 DYSON LONG NECK AIRBLADE WASH + DRY

WD06 DYSON AIRBLADE WASH + DRY WALL