Osram OPTOTRONIC OTi DALI NFC Dimmable Driver 10W 220-240V 150-700mA Constant Current

Product Information:

• Installation in emergency lighting systems according to IEC 61347-2-13
• Suitable for use in luminaires with flexible current setting
• Suitable for indoor SELV installations
• Suitable for luminaires of protection classes I and II
• Suitable for downlights, spotlights and LED panels
• Installation via Cable Clamp Kit possible (depending on version of product)
• Versatile DALI window driver due to flexible output characteristic
• Very high efficiency
• Protection of the system thanks to thermal management and Smart Control
• High-quality dimming of 1-100 % by amplitude dimming
• Easy and fast output current setting via NFC

Installing and operating information (SELV driver): Connect only LED modules. The LED module is shut down if output voltage is below 2.5V or above 45V. Wiring information (see fig. A): Do not connect together the output wires of two or more units. Output current adjustment via software programming of the DALI interface or near field communication. Connect the unit to a DALI programming interface (e. g. DALI Magic) and use the Tuner4TRONIC software on your PC, then follow the instructions. www.osram.com/ dali. For programming via near field communication see Tuner4TRONIC. Unit will get permanently damaged if mains is applied to the terminals 1-2 or 21-22. Max. total length of wires 21-22 2 m (excl. length of LED modules). The DALI interface provides a basic insulation against the mains supply. Emergency Lighting: This LED power supply is suitable for emergency lighting fixtures acc. to EN 60598-2-22; applies to EN 61347-2-13 Annex J